So, if my elevation is set to 0'-0" on the Level 1 View, then my Level 1 datum is properly set to 0'-0" when I export to NWC with the Shared coordinate point, correct? Thanks again for the help, hope both you guys are doing well. Three jobs in the past two weeks have cost us about 6 hours worth of labor on issues we believe are on them, not us, but since they are the customer they think they have it all figured out, or they don't care they just want us to "figure it out". This may sound a little harsh but after so many years of this, it's getting very frustrating the amount of time we have to waste trying to get origins set correctly. The Sensor Coordinate System (SCS) is placed at the upper left corner of your image, with the x-axis is horizontal and pointing to the right, and the y-axis is vertical and pointing downwards. I've checked, double and triple checked that I'm exported Shared in the Navis settings, that I have the Elevation set to zero, etc. Our customer set up these Navis models, not us, so before I go back and say "we are exactly located per your BEP" I wanted to ensure I wasn't missing anything on the elevation value. How to to Add GPS Coordinates and Layer Boundaries to Res2dinv interpret. Thing is, I'm wanting to find out if I'm doing something wrong, or if the customer is wrong. A step by step guide on Pole-dipole Array configuration preparation interpretation. The elevation isn't exactly 250ft difference.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |